- 15 -
Maintenance
You can prevent damages caused by sugar or sugar-containing dishes by cleaning
the hotplates with „Cerafix” or „Collo profi” agents, always or only before cooking the
sugar-containing dishes.
The mentioned agents cover the ceramic hotplates with a silicone film, not only
protecting but also making the surface even more “smooth”.
WARNING!
Dishes containing fats and oils as well as alcoholic drinks should be constantly watched
over! Fats, oils and alcohol may ignite when overheated!
If despite all your efforts, the fats and oils do ignite, never extinguish them with water!
Put a lid on, switch off the plate and carefully remove the pot from the hotplate.
Should cracks or splits appear on the surface of your ceramic plate, immediately
disconnect the plate from the mains and call Customer Service.
Important!
If you fail to observe the operating instruction you will lose your rights under
the warranty.
Installation of ceramic plate PB*4VQ2****
• make opening in the kitchen tabletop according to dimensions indicated on the
assembly drawing (Fig. A)
• minimal clearance which should be left under the ceramic plate is 80 mm
• connect the plate to the mains according to the attached diagram
• match the section of the conductor to the power of your plate (the operation
should be performed by a qualified electrician)
• unstick paper cover from the double-sided adhesive tape which is stuck on one
side to the surface of the plate ,
• remove dust from the tabletop, insert the plate into the opening and press hard
• fill the slot between the tabletop and the glass with silicone (Fig. B)
Kommentare zu diesen Handbüchern